C2N-SDC

Shade & Drape Controller, 2x 120VAC output

  • C2N-SDC: Front
  • C2N-SDC: Rear

Shade & Drape Controller, 2x 120VAC output

C2N-SDC

Shade and Drape Controller, 2 outputs for 120 VAC 3-wire bidirectional motors

More Details


The C2N-SDC is a 2-channel Shade and Drape Controller designed to provide a convenient and cost-effective solution for controlling a variety of motorized window treatments as well as motorized doors, sunroofs, lifts and projection screens. The C2N-SDC is a Cresnet device with two independently controlled 120V AC outputs. Each output provides up/down or open/close control of a conventional three-wire bidirectional type motor. Built-in timing and interlock logic make it easy to program the C2N-SDC for failsafe operation.

The C2N-SDC mounts in the wall or ceiling using an off-the-shelf 4" square or 2-gang electrical box. Pushbuttons on the front of the unit allow for manual operation of the motors during installation and setup.

1 UP/DOWN (2) buttons for local control of output #1
2 UP/DOWN (2) buttons for local control of output #2
SETUP (1) button used for touch-settable ID (TSID)
Ground (1) Class 1 flying lead, 14 AWG, green, ground
Hot (1) Class 1 flying lead, 14 AWG, black, line power input
Load 1 - 2 (2) 4-pin terminal blocks comprising (2) independent 120V AC 3-wire bidirectional motor control outputs;
Includes terminals for up/open drive (U), down/close drive (D), common/neutral (C), and ground;
Maximum Wire Size: 14 AWG
Neutral (1) Class 1 flying lead, 14 AWG, white, neutral
NET (2) 4-pin 3.5mm detachable terminal blocks;
Cresnet slave ports, paralleled;
Connect to Cresnet control network
Depth 1.15 in (29.2 mm)
Height 4.10 in (104.1 mm)
Width 4.10 in (104.1 mm)
Flat metal plate mountable in a 4-inch square or 2-gang electrical box, 1.5 inch minimum depth; mount 2-gang box horizontally to maintain correct orientation
Humidity 10% to 90% RH (non-condensing)
Temperature 41° to 122°F (5° to 50°C)
NET (yellow) Indicates communication with the Cresnet system
PWR (green) Indicates DC power supplied from Cresnet network
SETUP (red) used for touch-settable ID (TSID)
Load Types 3-Wire 120V AC bidirectional motors
Motor Control Channels 2
Per Channel 7.5 Amps, 1/3 HP
Total 15 Amps
Cresnet Power Usage 3 Watts (0.125 Amps @ 24 Volts DC)
Line Power 120 Volts AC, 50-60Hz, single-phase
0.55 lb (0.25 kg)

Available Models
Available Accessories